For a while I've been wondering if you could flood the chamber of a laser cutter with CO_2 routinely, not just to prevent fires but to prevent the scorching that laser cutting leaves on wood. If that would consume too much CO_2, would it be workable to instead spray it topically onto the point of the cut, a bit like the inert shielding gases that some forms of arc welding use?
Air assist is a classic thing on many decent laser cutters, especially for the reasons mentioned. On our lasersaur for example, a builtin air nozzle blow compressed air at the place where the laser beam hits the material being cut...
On reflection this probably can't work, as apparently wood melts only at stupidly high temperatures. Though maybe a lower temperature to embrittle the carbon would be enough?
